MG-1640 Probe Specifications
Stainless Steel Gas Analysis Sampling System with Integral
Probe
Mini-GASS™
Probe systems eliminate
heated lines entirely by mounting the conditioning system directly on a
stack probe. The sample is dried and cooled immediately after removal
from the stack to minimize changes in sample composition. This system
eliminates the expense of installation, operation, and maintenance of
heated lines, while faster sample equilibration reduces calibration
times, saving on the expense of calibration gases.
The Mini-GASS Probe incorporates all
the features of the Mini-GASS system and can be configured with the same
options. The Mini-GASS Probe also offers an optional heated blowback
assembly for its filter to minimize maintenance with high particle
levels, and Hastelloy® probe components for additional
corrosion resistance and temperature tolerance.
| Dimensions |
16" x 40" x 8" |
| Weight |
130 Lbs. |
| System Power Connection |
120VAC, 10A single phase supplied to
terminal block |
| Alarm Relays |
6 pole terminal block provided for the
connection of external alarm equipment. Contacts rated for
250VAC, 3A resistive.
- Low Purge - Flow < 10 lpm
- Low Temperature - Temp > 4 degrees below the set
point temperature
|
| Calibration gas requirement |
Sample flow rate plus 10%, 1/4" tube fitting |
| |
|
| |
|
| Heatless Dryer |
Maximum pressure 100 psig |
| Blowback |
Tank Volume |
0.7 scf when at 100 psig |
| Duration |
One half second minimum |
| Heater |
125 C |
| Connection |
3/8" tube fitting |
| Probe Filter |
Power requirement |
150 Watts at 115 or 230 VAC |
| Set temperature |
350 F (180 C) |
| Element |
2 micron ceramic |
|
